Need Help

[tylork92 10+ year member]

Vehicle: 93 Ranger.

OK...Bout to have evertything for my system together to be installed and am getting together stuff for Big3. But have a couple questions.

1) Does anyone the wire lengths i need (93 Ranger) i went and looked and have no clue which wires to measure. ( i kno its the alt to batt, chassis to block, batt to ground) But theres too many wires running together for me to figure this out.

2)is the wire all i need?...do i need battery terminals? If so negative and positive ones?

I kno this sounds TOTAL noob. but this is on e of the only tings i dont understand when it comes to CA.

Click to read more...

 

[tylork92 10+ year member]

ne one?

 

[modskwod 10+ year member]

Sounds like you should be good to go. As far as lengths, run a piece of rope/string where you want the wire to go and mark the length then measure it. Then cut the wire to the same lengths. Good luck!

 

[tylork92 10+ year member]

wat about battery terminals?

 

[undeadxsunshine 10+ year member]

wat about battery terminals?

depends on what your battery has on it now. you're gonna need ring terminals for each end of the wire, and you may need new battery terminals to accommodate the added ring terminal of the new runs.

 

[RED3 10+ year member]

don't believe you will need battery terminals, you will need crimp on ring terminals that match your wire size/awg and will fit the bolts you will attach them to. Make sure the connections are crimped tight. You just attach the additional wires to the various locations, you don't replace any oem wires. Should probably read up on the Big 3 before you do it.

 

[tylork92 10+ year member]

Ive done alot of research on it and understand what it does and how it works its just when i went and looked today going to measure the wires i got erally confused at the wires coming from my battery and was wondering about that.