Need help picking out wiring kit

[drums2351 10+ year member]

I am somewhat new to car audio and needed some help selecting the right wiring kit for my amps. This is what I have:

Alpine MRP-F250 40W RMS at 4 ohm. This will power two type-r components and two infinity components.

Kenwood XR-1S 600w at 4 ohm. 4-Guage Full-contact. This will power a 12" Dayton Reference HO Subwoofer.

Do I have to get an individual wiring kit for each amp? Also, should I bridge the amps? Someone suggested Knukonceptz wiring. I am going for sound quality mainly. Any help is appreciated.

Click to read more...

 

[Jh8909 10+ year member]

you would actually be fine with Knu 4 gauge, but if you ever wanted to upgrade I would Just get the knu 0 gauge off the bat.

 

[AQHDC3 10+ year member]

Ya run 0 gauge into a distribution block with two 4 gauge outlets and run one into each amp.

 

[drums2351 10+ year member]

So would I need to get both the Complete 4 Gauge Amplifier Installation Kit for the subwoofer amp and then the Complete 4 Gauge 4 Channel Amplifier Installation for the components?

 

[drums2351 10+ year member]

Ya run 0 gauge into a distribution block with two 4 gauge outlets and run one into each amp.

Where do you plug the 0 guage into then?

 

[SlipTap 10+ year member]

===0 Gauge===|Distribution Block| ---