budget76
10+ year member
fawkin' newb
Didn't take many pics, as it's not done 100% yet. I'll post up more. It's a 2.2 cube enclosure at 32hz for a single 10, 4" aero port using PVC. The sub enclosure is integrated into a larger enclosure, so I have a storage area. This will be a foot stool/seat since it's taller than ideal for when sitting on most couches. Have a velodyne 200rms, 400 max amp in there, it's PLENTY.
I used an ***-ton of screws on the sub/aero mount board because I did not glue this one. I decided to silicone the **** outta it, because I may want to switch sub sizes, but dont' want to make the whole thing again. Barely got all the pieces out of a 4x8 sheet, which is up to $26 here
Still have to fab up some feet out of something, and mount the remote for the amp. The top will get some type of cushion, and the interior lined with a thing foam/carpet so rattles will be quiet.
It'll be PLENTY for my dorm room:laugh: Thoughts/opinions? Oh, all done with a circular saw and router. No flush cut bit. Biggest variation in cuts was 1/10" //content.invisioncic.com/y282845/emoticons/cool.gif.3bcaf8f141236c00f8044d07150e34f7.gif
I used an ***-ton of screws on the sub/aero mount board because I did not glue this one. I decided to silicone the **** outta it, because I may want to switch sub sizes, but dont' want to make the whole thing again. Barely got all the pieces out of a 4x8 sheet, which is up to $26 here
Still have to fab up some feet out of something, and mount the remote for the amp. The top will get some type of cushion, and the interior lined with a thing foam/carpet so rattles will be quiet.It'll be PLENTY for my dorm room:laugh: Thoughts/opinions? Oh, all done with a circular saw and router. No flush cut bit. Biggest variation in cuts was 1/10" //content.invisioncic.com/y282845/emoticons/cool.gif.3bcaf8f141236c00f8044d07150e34f7.gif
