My Brahma arrived

[IamDeMan 5,000+ posts]

Please take the plastic cover off the backplate before you melt the driver. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif
All versions had pole vents... Changes through the years were mainly cosmetic.

OK, so I am a noob when it comes to these less known internet brands lol. I will uninstall it and take care of that right now. Every **** RF/Infinity sub I bought didn't have a cover over the pole vent lol.

Once again Jlaine thanks bruh //content.invisioncic.com/y282845/emoticons/2thumbs.gif.fdc3ba010dbb42b61704534b46d02fe4.gif

i must say that is a clean install, you hid all the wires nicely. im givin ya a hard time. port that sub if it was anything like my xxx it will come alive

Ya, someone else already mentioned this in the thread. This install is totally temporary, once I settle on the equipment, it will be a much nicer install. I am going to either try my hand at glassing the enclosure into a corner or have a local shop do it, then make a much nice amp rack than that. Right now it keeps everything from sliding around while I test gear out and make decisions.
EDIT:All is well now. I just went out and took the woofer out and removed the plactic tupperware lid. I feel like an idiot.