My Box Fab.

joerodd
10+ year member

Junior Member
23
0
NW Ohio
I was planning on building my box and i found the wood to do it and all, but i wasn't sure how the constructions of a ported box would go. I any one has a suggestions i would be much appreciated. It is for 2 alpine 1221 12" type r's. Thank you. I'm new on the whole car audio scene but im looking to get into it. I am having some one help my wire this all.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Sounds like you need new coils. My Explorer with three 15's, appropriate birch box, fully sound-deadened interior, and a boat behind it does not...
2
1K
Have you checked out these shallow drivers from DD? A friend had 4 of them and man, it took it to the house for what they are...
6
182
My guess is, once you get the speaker in it, more like 34hz so good to go. With that unit, try it up, try it to the rear, see which works best...
12
463
I’m leaning towards the xv3 tbh. I’m also leaning towards adding the rings or if I can figure out how much taller to raise the top portion of the...
16
959
Start by laying the larger bottom panel in an open space, then slowly “dry” assemble it by laying the pieces where they go like a puzzle. It...
1
679

About this thread

joerodd

10+ year member
Junior Member
Thread starter
joerodd
Joined
Location
NW Ohio
Start date
Participants
Who Replied
Replies
0
Views
466
Last reply date
Last reply from
joerodd
20240723_125956.jpg

Bobbytwonames

    Jul 26, 2024
  • 0
  • 0
20240723_125945.jpg

Bobbytwonames

    Jul 26, 2024
  • 0
  • 0

New threads

Top