Mpyre Mids, EQ Screamers, and (2)Sundown 125.2's

[SPLluminator 10+ year member]

How would you wire it? I figure i would wire comps to one amp, tweets to the other. But how do i set my crossover point?

Click to read more...

 

[here to buy 10+ year member]

set the screamers to 3k,

and the mypres to 3k or a lil higher, they start to cutoff pretty low though.

on the tweeter amp, highpass at 3k.

on the mypre amp, lowpass 3k

 

[SPLluminator 10+ year member]

Thats all there is to it? Or woudl i have mids on flat?

 

[here to buy 10+ year member]

u could send all the freqs to the mids, but you shouldnt

you will run into phase and cancellation issues and sound a lil muddy, thats what the tweets are for

especially with the mypres, they cutoff low.

all mids beam at a certain frequency point, and cutoff steep around there

 

[SPLluminator 10+ year member]

Ok so set the cutoff around 80?

 

[here to buy 10+ year member]

nahhhhh set the lowpass cutoff of the mypres to 3000hz,

you can subsonic them low, as they handle the lows as well as any mids ive heard.

you can set them to 50 or 63 just fine.

 

[RAM_Designs 5,000+ posts]

Bandpass the mids from ~60hz to somewhere between 2k-3k. Then just high pass the tweets in the 2k-3k area, and tinker with it to find what sounds best to you.

 

[SPLluminator 10+ year member]

Ok thanks soo much for your help HERETOBUY and RYANM923. Its appreciated.