More van woes

After I ripped the wall out, somehow the locks, interior lights, and radio arent working. I dont know if they are unrelated or not, but it seems odd if they could be related. I didnt cut any wires or anything either to my knowledge.

All fuses are good for all of those.
Exactly what got doe inside your van when this "ripping the wall out" process happened?

It may take a bit but take me step-by-step through what you did...

Obviously something happened so let's see if we can work out what it was.

 
Well tearing wood out lol.

Sawzalled through one of the sides, but that was on the sliding door side, and I went from outside in if you understand what Im saying. The rest I just unscrewed/bolted and beat out with a hammer and my brute strength //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif.

 
Well tearing wood out lol.

Sawzalled through one of the sides, but that was on the sliding door side, and I went from outside in if you understand what Im saying. The rest I just unscrewed/bolted and beat out with a hammer and my brute strength //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif.
Was there any audio wiring run into the interior of the outside panels where the vehicle wiring is?

 
No all powers/ground were ran underneath the the car, up through a hole in the floor. The only thing else was the speaker wires, which had a small hole in the box that went directly to the amps.

 
No all powers/ground were ran underneath the the car, up through a hole in the floor. The only thing else was the speaker wires, which had a small hole in the box that went directly to the amps.
Was the power cabling still connected to power as this uninstall was happening?

Did you possibly short something to ground as it was removed?

I'm just grasping at straws here, fella. Hard to troubleshoot something you're not looking at //content.invisioncic.com/y282845/emoticons/crap.gif.7f4dd41e3e9b23fbd170a1ee6f65cecc.gif

 
Ha yea I know what your saying. Well the power and ground were connected to buss bars. I took those off first, and did each power one by one, and taped them all up with elec and duct tape. They never grounded out.

 
accessories relay maybe?

dunno man since you said all fuses are fine .

might also be wire loose at battery terminal. i would start there and work my way back if eveyrthing looks ok under the hood then check the fuse box to see if it is getting current with a dmm if it is then you know the problem isnt the power or the fusebox .

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

btnhfan

5,000+ posts
Hail to the King Baby!!!!
Thread starter
btnhfan
Joined
Location
CT/ GA Tech, Atlanta
Start date
Participants
Who Replied
Replies
14
Views
712
Last reply date
Last reply from
MadAudio
design.jpeg

WNCTracker

    May 22, 2026
  • 0
  • 0
IMG_2118.jpeg

WNCTracker

    May 22, 2026
  • 0
  • 0

New threads

Top