- Thread Starter
- #3
Where would i need to put them?
i would put some between the subs on the left and right side and maybe some little triangle braces in the corners and below the subs
j3bus2k3
5,000+ posts
Si vis pacem, para bellum
He wont need them. The port walls themselves will act as proper bracing. All I would worry about would be some triangle braces in the corners and thats it.
woc47
10+ year member
That's How I Roll
yep place them in the corners, the center port can support alot of weight
- Thread Starter
- #7
This will be my first box.. so i'm not sure what traingle support is can you explain to me or maybe a picture of one... Thanks!
Abel
10+ year member
CarAudio.com Veteran
all i can say is Build it,test it, and probably build another one //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif thats how it always goes
woc47
10+ year member
That's How I Roll
it's a 90 degree triangle, place it in the corner of the box and screw it in from the outside. All this does is adds support to the sides bottems and tops from flexing and pulling apart.
- Thread Starter
- #10
where do i get one?
From about 5 boxes ago. Look in the top right corner, that's a triangle brace. It wasn't necessary on this enclosure, so I just used apiece of scrap and didn't make it the height of the box. You should always want to make it as tall as the inside though, that way you can couple the corner to the top and bottom.
lilmaniac2
5,000+ posts
Ask Me about SI Mag V4!
i woudl say your friend needs a copy of sketchup
- Thread Starter
- #14
would it be a good box though?
Activity
No one is currently typing a reply...
