Konaki Motor Mods

[negative3five 10+ year member]

send the motor off to be demagnetized, and then instead of ****ing up the steel just have a machine shop duplicate the pieces to your new specs?

Very good idea I didn't think about that, o and I was thinkin you gotta be able to demagnatize one what about all those shifted pole vents, all I gotta do is have em demagnatize it send me the top and bottem plates and ill bring em to a machine shop send em back and have em put it together and magnatize it for me make recones for em but that'd take awhile that's a lot of money and if I went that route id have em prob make like 32 dif bottem and top plate combos and try to find mags that will fit test all my combos to the fullest lol. I might Just try seein if anyone that can magnatize it has mags that will fit then I can just bust apart the mags and make the changes I want on the steal I have and send it to them to get magnatized and reconed that'd be cheaper.

 

[Korn4Life 5,000+ posts]

Very good idea I didn't think about that, o and I was thinkin you gotta be able to demagnatize one what about all those shifted pole vents, all I gotta do is have em demagnatize it send me the top and bottem plates and ill bring em to a machine shop send em back and have em put it together and magnatize it for me make recones for em but that'd take awhile that's a lot of money and if I went that route id have em prob make like 32 dif bottem and top plate combos and try to find mags that will fit test all my combos to the fullest lol. I might Just try seein if anyone that can magnatize it has mags that will fit then I can just bust apart the mags and make the changes I want on the steal I have and send it to them to get magnatized and reconed that'd be cheaper.

If u just need the top and bottom plates just take a hammer to the Magnets... U dont need them right?

 

[negative3five 10+ year member]

Yea that's what im most likly doin if I can find mags to fit I can do the rear vents and machine the top with the drill press and smooth it out with the dremel but that's if they got mags to fit and a magnatizer and a coil in stock that'll fit im broke so id prob only be able to do one with all the mods I want and test it out against a stock one with the same recone //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif.