Kicker ZX 750.1 blinking protection! HELLPPP

chasestrickland
10+ year member

Junior Member
WTF my zx 750.1 took a dump for no reason. When I hook it up and turn the car on it just goes in to like a pulsating protection mode. Im thinking that it has to be an internal problem because I can unhook that amp and hook up my Audiobahn 750 2 channel amp and it works perfect. Anyone have any ideas on what it might be???

 
What kind of subs are you pushing? Are they dual 4ohm or dual 2ohm? What size cable are you using? Also what kind of car is it in? Were is your ground cable grounded on?

 
Its just a single 15 inch CVR dual voice coil 2 ohm , in a Chevy Blazer. And its grounded to a seat bolt for one of the rear seats. I just dont understand because my other amp runs it fine. But it is a 2 channel. How could I increase the load?? And the gain is all the way down

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

chasestrickland

10+ year member
Junior Member
Thread starter
chasestrickland
Joined
Location
Vero Beach, FL
Start date
Participants
Who Replied
Replies
6
Views
2,997
Last reply date
Last reply from
johnbubby5
1778578257023.png

Glen Rodgers

    May 12, 2026
  • 0
  • 0
Screenshot_20260511_212804_Amazon Shopping.jpg

Blackout67

    May 11, 2026
  • 0
  • 0

New threads

Top