Ummagawd
CarAudio.com Newbie
I have a Stelvio in which I plan to replace the factory 8” sub for a CDT QES820. I already have an LC2i and NVX BDA7051 amp. So it will be a good match if I wire the CDT for 4ohms.
my question though is if I should pickup a bass processor to replace the LC2i (just in case the Harmon Kardon amp is EQing the sub) or if I should just get the key500.1 and wire the CDT for 1ohm.
which of these routes will give me the “fullest” signal?
my question though is if I should pickup a bass processor to replace the LC2i (just in case the Harmon Kardon amp is EQing the sub) or if I should just get the key500.1 and wire the CDT for 1ohm.
which of these routes will give me the “fullest” signal?
