Kenwood DMX 706S 'NO Signal' error.

  • 3
    Participant count
  • Participants list

bigron81

CarAudio.com Newbie
5
0
Dallas
Hello Folks,

Just joined the forum and looking forward to an enriching experience.

Coming to my issue, after much deliberation bought the Kenwood DMX 706s.
However, using the AV IN input via the Kenwood CA-C3AV cable connected to a HDMI to RC convertor and into mu phone through a usb c to hdmi, I get a ' no signal' error on screen. I know the usb c-hdmi cable and the hdmi convertor works because it can output on to my TV at home through my phone.

Any settings I need to change or probable causes I can look at.
Looking forward for your views. Thanks in advance.
 
Okay, so I managed to get audio. The video is not being mirrored to the screen and gives the 'No Signal' error.
Do I ground the green parking brake wire of the HU?
 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Hi Ferdi.. Yes I have had a brand -new DMX5020 installed last week and it does almost as you described. Once the phone is connected it's all...
1
1K
I got it to work, I was plugging in the subwoofer while the amp had power. I unhooked the remote turn on lead, then all speakers plugged in, then...
4
334
First off, seems to me you have the specs backwards. Ignore peak, stick to RMS. Neither of them is going to do great at 60hz, that is really...
1
275

About this thread

bigron81

CarAudio.com Newbie
Thread starter
bigron81
Joined
Location
Dallas
Start date
Participants
Who Replied
Replies
3
Views
6,582
Last reply date
Last reply from
ThxOne
1000006564.jpg

Mr FaceCaser

    Mar 28, 2024
  • 0
  • 0
1000006569.jpg

Mr FaceCaser

    Mar 28, 2024
  • 0
  • 0

Latest topics

Top