Is a Crunch 1400.4 too much for the ID or PPI comp sets?

galacticmonkey
5,000+ posts

Wants a button like that.
I have a kid that is looking for a good budget comp set, and has a Crunch Powerzone 1400.4. If it were to be bridged, would that be too much power for either the PPI set? Dont remember the mode number, but the ones that are coming up as a forum boner. Would the ID CTX65 do ok with the power?

Some people say they run crazy power and it takes it no problem, but just wondering if they would do ok this this amp, since I have no experience with these sets or how much power they will actually take.

This is the power rating, but its rated at max, and will probably do around 1/2 that, maybe a little less.

Power @ 4 Ohm: 700W x 2

Power @ 2 Ohm: 350W x 4

Power @ 4 Ohm: 175W x 4

 
I think its 2 CVX 15s. I talked to him and I think he isnt going to bridge it. Pretty sure he wants to run the front 2 channels on the comps, then use the back 2 channels for 2 sets of coaxs in the rear deck.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

galacticmonkey

5,000+ posts
Wants a button like that.
Thread starter
galacticmonkey
Joined
Location
Tampa, FL
Start date
Participants
Who Replied
Replies
9
Views
1,492
Last reply date
Last reply from
galacticmonkey
design.jpeg

WNCTracker

    May 22, 2026
  • 0
  • 0
IMG_2118.jpeg

WNCTracker

    May 22, 2026
  • 0
  • 0

New threads

Top