instead of viewing my thread plz post back instead :P i need help 2 12 inch mtx 9500

[Mclovin it son 10+ year member]

So overall ill run the mtx 9500s at 4 ohm for now and then i should get a kinetik hc800?

either do that or instead of doing that fuse both positives, and ground each battery seperately to chassis (front bat to chassis, rear bat to chassis)
run positive from rear bat to amp pos and amp neg to rear bat neg

 

---------- post added at 02:12 am ---------- previous post was at 02:11 am ----------

 

absolutely that would cut down the current draw hella

 

[stl_314 10+ year member]

That should be fine til you get atleast another battery, regardless of what everyone says amps do no steadily pull max amps from the batteries so depending on how loud and for how long you listen to it you might not need an alt.

I had an aq 2200 and mtx 304 on a stop 95 amp alt with 1 deka 9a31 and never dropped below 12.8 full tolt for 45 minutes, so I did not feel it was worth paying for an alt

 

[Mclovin it son 10+ year member]

Try it out u may get lucky and not need a alt i dont cranck it up all the way neways

that should be fine til you get atleast another battery, regardless of what everyone says amps do no steadily pull max amps from the batteries so depending on how loud and for how long you listen to it you might not need an alt.
I had an aq 2200 and mtx 304 on a stop 95 amp alt with 1 deka 9a31 and never dropped below 12.8 full tolt for 45 minutes, so i did not feel it was worth paying for an alt

 

[Mclovin it son 10+ year member]

thx peeps

 

[SourDeez 10+ year member]

No problem bud

 

[Mclovin it son 10+ year member]

one last question, instaed of wiring both subs down to 4ohm would i be able to wire each sub seperately at two ohm? will that still come out to 4 ohm load?