Installing 6x9s..

[ProcalX 10+ year member]

I have no original wiring within the car as i got the car cheap as a project, i have a new Sony CDX-S2050 headunit ready to install and two 300W 6x9 150W rms speakers which i would like to install into the boot shelf (parcel shelf) at the back of the car..

I'm going to have install all the wiring myself and don't really have a clue on how to go about doing it?

could anyone provide some simple steps & or tips?

Click to read more...

 

[supa_c 5,000+ posts]

You want to run 2 new leads to the rear of the car. Start by removing the necessary trim, seats and what not to make the installation eaiser on yourself.

Im not shure if you know what butt/splice connectors are but you might want to pick some up if you dont know how to solder. As well as some spade connectors for the speaker.

Spice the new wire into the harness. Run the wire the length of the car from H/U to speaker. Make shure you compensate for bends and other things. Its not too hard if the car is already torn apart.

And for you n00bs out there...

Boot shelf/parcel shelf= rear deck

 

[ProcalX 10+ year member]

ok thanks