Ignorant question...

[Railrocker 10+ year member]

no you can use the same harness but it wont be plug and play you will still have to wire one side of the harness to your head unit.

Click to read more...

 

[SVTLightning01 10+ year member]

just to clear it up....you can use the vehicle harness , but oyu would have to cut it and reconnect it to the apline harness. If it was a pioneer deck your switching to, it might be possible.

 

[dkguitarist 5,000+ posts]

you'd still have to replace the RADIO WIRING HARNESS but you can keep the VEHICLE WIRING HARNESS. just take the RADIO WIRING HARNESS and connect it to one side of the VEHICLE WIRING HARNESS and you're set. //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

 

[Shyne151 10+ year member]

If it was put in at a circuit city, it might be a smart harness. If it is then it would be plug and play //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

But more than likely you'll just use the vehicle harness and solder the radio one to it.

 

[MrLaRotta 10+ year member]

Yeah, cut the car harness and connect each wire of the radio harness where the car harness used to be... just make sure to save the original car harness, you may need it when shelling the car and installing the old radio

 

[MrLaRotta 10+ year member]

Never EVER cut the car's harness off. Always strip the wire behind it back and splice in.

Hummm, diferent taste //content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gif hehehehehe