I have a decision to make.

[T.I.K. 10+ year member]

I can either run my RUBI2500 at 1 ohm, and DMM set it to around 1000-1500w or get what I can out of it at 4 ohms. I ran out of money for an extra battery and 0ga wire, so I'm just gonna reconnect my old Big 3 and order a 4ga wire kit and run it for about 3 months like that. So which should I do?

Click to read more...

 

[bgowdy 5,000+ posts]

I can either run my RUBI2500 at 1 ohm, and DMM set it to around 1000-1500w or get what I can out of it at 4 ohms. I ran out of money for an extra battery and 0ga wire, so I'm just gonna reconnect my old Big 3 and order a 4ga wire kit and run it for about 3 months like that. So which should I do?

i was gonna say 4 ohm would be better but i would just go 1 ohm and set it. theres no garuntee to get the 1000@4ohm. and to set it to 1k - 1.5k is not gonna pull hard on your electrical

 

[bgowdy 5,000+ posts]

i was gonna say 4 ohm would be better but i would just go 1 ohm and set it. theres no garuntee to get the 1000@4ohm. and to set it to 1k - 1.5k is not gonna pull hard on your electrical

ok that looked confusing lol... just go 1ohm & set it to 1 - 1.5k

 

[T.I.K. 10+ year member]

It's straight, I understood what you said. I've had 1500w on my electrical again, but I didn't have a high's amp before, so I have to account for that as well :/

 

[rebelfromva 10+ year member]

Try 4 ohm first if your not satistfied after a day or two switch to 1 ohm.