How much to build this box

[john denver 10+ year member]

The box is 21.25 wide 21 deep 14.75 high with a double baffle on top back wall of port is 7.5 across and 17.25 deep 3" wide port.

Would like the whole box built with one piece from the left front corner all the way around to the end of the port all .75" radius on all corners .25" radius at end of port. would like to know if anybody would be able to build this box and how much they would charge for building and shipping the box.

Click to read more...

 

[PhatTonyDeMarco 5,000+ posts]

It would be impossible to be one piece, it exceeds 8ft

 

[john denver 10+ year member]

It would be impossible to be one piece, it exceeds 8ft

I quess your right didnt think about that when i started drawing it out:verymad:

 

[Pioneer~Saturn 5,000+ posts]

You could always rabbit two ends and butt them together and sand it down it'd just look like a faint line //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif...it could easily be done //content.invisioncic.com/y282845/emoticons/cool.gif.3bcaf8f141236c00f8044d07150e34f7.gif

 

[john denver 10+ year member]

You could always rabbit two ends and butt them together and sand it down it'd just look like a faint line //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif...it could easily be done //content.invisioncic.com/y282845/emoticons/cool.gif.3bcaf8f141236c00f8044d07150e34f7.gif

pm'ed you back

 

[azimuth 5,000+ posts]

12 foot sheets are your friend.

 

[john denver 10+ year member]

12 foot sheets are your friend.

Where do you find the 12 foot sheets at that must be ***** to haul around

 

[azimuth 5,000+ posts]

Where do you find the 12 foot sheets at that must be ***** to haul around

they **** to haul around. i get mine at a place called "the lumber guy". they don't always have it, but usually.

 

[bjfish11 5,000+ posts]

I did a box similar before. Looked pretty cool.

The thing that worries me about yours is the .75" radius on the corners. Not sure if you can bend it that tight. I use a 3.5" radius generally...

 

[wasted ink 10+ year member]

I did a box similar before. Looked pretty cool.
The thing that worries me about yours is the .75" radius on the corners. Not sure if you can bend it that tight. I use a 3.5" radius generally...

pics?

 

[mobeious 10+ year member]

ya the place were i get lumber has 4x8 and 5x10 sheets that would be hell cutting not hard though just alot of cuts better have a cabinet saw to with a 60" fence

 

[bjfish11 5,000+ posts]

pics?

http://www.caraudio.com/forum/showthread.php?t=234175&highlight=build+ionsql

 

[wasted ink 10+ year member]

that was a little before my time here.. a little late, but nice job //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif