Hooking a bridged 4 chnl to a DVC sub

[Railrocker 10+ year member]

Ok so My sister wants a system. I dont have the money to spend on her right now but I have a 200a4 sitting in my garage. I cant find any subwoofers that will work on 100 wrms. This may be a stupid question but Ive never tried it or seen it done. I was wondering if I could bridge the amp to 100x2 and run a channel to each VC on a DVC sub to give it 200wrms.

Click to read more...

 

[Railrocker 10+ year member]

Is it that silly of a question? ttt

 

[Death By Bass 10+ year member]

yes, thats possible.

 

[Railrocker 10+ year member]

Sweet thanks! That will save me some money.

 

[MrSwiss 10+ year member]

i believe u can bridge all 4 channels yes? down to a 2 ohm load

 

[Death By Bass 10+ year member]

i believe u can bridge all 4 channels yes? down to a 2 ohm load

you cant.

but you can bridge two channels into a single 4 ohm load, and use a dual 4 ohm sub...

 

[MrSwiss 10+ year member]

you cant.
but you can bridge two channels into a single 4 ohm load, and use a dual 4 ohm sub...

sry i worded that wrong...

i believe u can bring all 4 channel "amps". not all 4 channels.

would that be channels'?