Hifonics ZXi1006

[systembumping 10+ year member]

Ok I just picked up a brand new Hifonics ZXi1006 and I have a problem. I hooked it up to two 15''s at 2 ohms stereo and I can't hear anthing out of the speakers, just a slight vibration from the music. I put my gain halfway, I set in on LP/BP, Low pass halfway up, high pass down, bass halfway. It might be a defect in the amp or something I don't know. When I had my speakers hooked up to my Power Acoustik Lt 980/2 they hit pretty hard so I don't know what's wrong. Please help.

Click to read more...

 

[systembumping 10+ year member]

Somebody please help before it gets too dark, I wanna hear this thing rumble!!!

 

[systembumping 10+ year member]

Nobody knows whats wrong?

 

[MrSwiss 10+ year member]

check your wiring

 

[systembumping 10+ year member]

I did, I even took my headunit out to see if my RCAs were good. I mean all I did was take one perfectly working amp out and put in a new one. How can I tell if my RCAs are bad? They worked perfect with the other amp.

 

[matrxx dude 5,000+ posts]

recheck all your gains and filters,and if it has slave master switch,put it on master

 

[systembumping 10+ year member]

What is a slave master switch? I can't figure out what's wrong.

 

[systembumping 10+ year member]

I know somebody has had this problem before.

 

[Slowd N Throwd 10+ year member]

do you have a volt meter? see it its getting 12 volts

 

[systembumping 10+ year member]

I don't have a volt meter. What is a slave master switch?