Help!

  • 2
    Participant count
  • Participant list

drummer_punk82
10+ year member

Member
73
0
Michigan
Ok, here's the stuff I got:

Sony Xplod 150W RMS @ 4ohms(stereo) OR 380W RMS @ 4ohms(mono)

2X JL Audio subs W3 10" @ 4ohms & 250W RMS

Yes, I do know that my amp isn't the greatest for the type of subs I got, but I didn't have much $$$ and really wanted to get some bass going.

Now, I was wondering if I could bridge both subs to the amp. Meaning put both of the "+" wires in the "+" terminal and both of the "-" in the "-" terminal without blowing anything up. Would the ohms be mismatched and eventually blow the amp?

 
If the 10w3s are dual 4 ohm, and you hook both the voice coils and speakers to the amp in paralell, your amp will see a 1 ohm load, more like .8 ohms. You should not do this unless your amp is stable at 1 ohm mono. Some of the sony es amps are. check the owners manal.

 
If the 10w3s are dual 4 ohm, and you hook both the voice coils and speakers to the amp in paralell, your amp will see a 1 ohm load, more like .8 ohms. You should not do this unless your amp is stable at 1 ohm mono. check the owners manal.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

That would be a function of the harness, not the HU, I think. Have you looked into a Maestro or iData interface? i would check with crutchfield...
12
229
Dammned good speakers. Just pass up the CL series,and you will be pleased with CDT speakers. I still enjoy all mine. Polk MM series and Infinity...
4
189
The cutting it off part is what I'm confused about now. The speakers in my car have two wires coming off of them but I would only have one wire on...
2
306

About this thread

drummer_punk82

10+ year member
Member
Thread starter
drummer_punk82
Joined
Location
Michigan
Start date
Participants
Who Replied
Replies
2
Views
439
Last reply date
Last reply from
indosia
1716436519534.png

Doxquzme

    May 22, 2024
  • 0
  • 0
tip.gif

1aespinoza

    May 22, 2024
  • 0
  • 0

New threads

Top