Help HELP PLEASE NEED HELP FAST

coledawg
10+ year member

Where the Hell am I?
Installed the h/u today and spliced all the wires going by the colors in the booklet to the wires in the old wire harness "had the names on them"

and hooked the amp rca's to the "no-fader/low" rca out

everything worked fine at first till we put a rap song for about 10 seconds then it went into protect till we turned off the h/u and when it turned back on, the sub was fine.

went back into protect when a bassy song was played again

checked ground, remote turn on, heat, rca's and unhooked the sub.

-when the sub was unhooked, we played a tone ~50 hz and it went into protect after about 30-45 seconds

So basically its either the wiring, amp or some messed up signal coming from the h/u

Any help is greatly appreciated -Cole

had to move to proper section*

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

coledawg

10+ year member
Where the Hell am I?
Thread starter
coledawg
Joined
Location
Macon,GA
Start date
Participants
Who Replied
Replies
1
Views
388
Last reply date
Last reply from
coledawg
IMG_20260513_214311575.jpg

ThxOne

    May 13, 2026
  • 0
  • 0
IMG_20260513_213956814.jpg

ThxOne

    May 13, 2026
  • 0
  • 0

New threads

Top