Got the Big 3 Done! (with vid!)

shipped? it would be way cheaper to meet halfway and just gimme gas money. lol but shipped even that far would be like 50 or more bucks.
I see,gimmie till next friday,or sooner if i make a little dough,and where would you say meet,and it's a bill right?

 
i remember i did that once lol ground bigger than my power and my power wire melted all the way down to the amp terminals haha luckily i saw it before my amp fried haha (this was about 2 years ago) btw we have the same head unit i think.
try again bubb. If the ground is bigger, thAt is completely fine, could not hurt ur amp one bit. Sounds like u just don't no what ur doing, plain and simple.

 
I see,gimmie till next friday,or sooner if i make a little dough,and where would you say meet,and it's a bill right?
probly kaufman off 175 would be around half. and 140 for me to go out there and back? gas and some lunch? still cheaper than around 160+ shipped. //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 
try again bubb. If the ground is bigger, thAt is completely fine, could not hurt ur amp one bit. Sounds like u just don't no what ur doing, plain and simple.
this was 2 years ago. i know what im doing and it burned the power wire. i was using a cheap amp kit that was like 12 bucks and a big 4 gauge rf ground and my power wire burnt. and no then i didnt know what i was doing but thats not now

 
What amp and how big was your power wire?
it was an alpine mrp m450(500 rms at 2 ohms) i was running 1 type r the ground was rf 4 gauge and the ground was supposedly 4 awg but it was one of the really really cheap amp kits off of ebay that was like 12 bucks. must of been really like 12 or 16 awg.

 
Who says u no what ur doin now. If u thought that was ur problem now, ur ground to big caused ur power to melt,

u obviously don't no what ur talkin bout.

Am I right?
i know what im doing because i say i know what im doing and i install my own sh*t and have no problems at all. and im not going to keep post dumping in this guys thread. im out

p.s- that had to bethe problem because once i mached the ground and the power to the same awg there were no problems.

 
it was an alpine mrp m450(500 rms at 2 ohms) i was running 1 type r the ground was rf 4 gauge and the ground was supposedly 4 awg but it was one of the really really cheap amp kits off of ebay that was like 12 bucks. must of been really like 12 or 16 awg.
now ur saying that the ground was smaller and before u said it was bigger. U need to get ur facts straight bro.

Quit making urself sound like a dumbass bc i no ur not. Maybe u are and were just born like that, im sry for u disability.

 
now ur saying that the ground was smaller and before u said it was bigger. U need to get ur facts straight bro.
Quit making urself sound like a dumbass bc i no ur not. Maybe u are and were just born like that, im sry for u disability.
messed up typing. the ground was indeed bigger than the power. switched the wires and made them the same awg and problem was solved. So it can happen and it did. im done here.

 
probly kaufman off 175 would be around half. and 140 for me to go out there and back? gas and some lunch? still cheaper than around 160+ shipped. //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif
Ahh...easy,i'll hit you up if this other deal goes sour,think i can get a demo?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

twistedchild420

5,000+ posts
CarAudio.com Veteran
Thread starter
twistedchild420
Joined
Location
East,TX
Start date
Participants
Who Replied
Replies
29
Views
1,229
Last reply date
Last reply from
twistedchild420
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top