google sketch up

[Mr Bojangles 10+ year member]

Designing a speaker box. Is there any way you can tell it to draw with wood instead of a single line? Or do you have to manually draw out every piece of wood?

Click to read more...

 

[j3bus2k3 5,000+ posts]

For a panel, just do a rectangle then use the push/pull tool to give it height...

 

[Calikid 5,000+ posts]

i just downloaded too, easy to use , learned in about 2 minutes. //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[Mr Bojangles 10+ year member]

i just downloaded too heh.. already built my next box on it.. But is there any way to set it to automatically make it 3/4 every time i make a panel?

 

[j3bus2k3 5,000+ posts]

not that I've found...just draw your bottom out and they lay a map of every other panel. Use push/pull to give them height. Thats always been my method...

 

[Chevyaudio 5,000+ posts]

no...you have to Push/Pull everything.

Its not that difficult.

 

[Mr Bojangles 10+ year member]

what you mean by laying a map.. You can lay out the box before you make it?

 

[j3bus2k3 5,000+ posts]

Naw, I draw my bottom out and give it height. then on top of it, I draw the rectangles that will soon form the base for every panel that sits on top of the base...I have a pic mid-design, I'll find it to illustrate what I mean...

 

[Mr Bojangles 10+ year member]

gotcha. Nice..