Hey guys, I have a US Acoustics USB 4065 amp for sale, I want to use it, but it is a little too tall for my application. I think it is 2.5 inches tall.
Anyways here are the specs:
65 watts RMS x 4 at 4 ohms
80 watts RMS x 4 at 2 ohms
160 watts RMS x 2 bridged output at 4 ohms
2-, 3-, or 4-channel output
4-ohm stable in bridged mode
Tri-way capable (Tri-Way crossover required)
variable high-pass crossovers (12-200 Hz, 12 dB/octave), front and rear channels
variable low-pass crossovers (40-200 Hz low-pass, 24 dB/ octave), front and rear channels
preamp outputs with crossover
anti-thump circuit
thermal, short-circuit, and power/ground reversal protection
13-3/8"W x 2-5/8"H x 9-5/8"D ( I don't think it is quite that big though, I will take actual measurements in the AM)
It would make a great little amp for a nice active setup, I can have some pics tomorrow.
Asking 100 shipped
Thanks!
Anyways here are the specs:
65 watts RMS x 4 at 4 ohms
80 watts RMS x 4 at 2 ohms
160 watts RMS x 2 bridged output at 4 ohms
2-, 3-, or 4-channel output
4-ohm stable in bridged mode
Tri-way capable (Tri-Way crossover required)
variable high-pass crossovers (12-200 Hz, 12 dB/octave), front and rear channels
variable low-pass crossovers (40-200 Hz low-pass, 24 dB/ octave), front and rear channels
preamp outputs with crossover
anti-thump circuit
thermal, short-circuit, and power/ground reversal protection
13-3/8"W x 2-5/8"H x 9-5/8"D ( I don't think it is quite that big though, I will take actual measurements in the AM)
It would make a great little amp for a nice active setup, I can have some pics tomorrow.
Asking 100 shipped
Thanks!
