SOLD FS Tsunami db1100d amp 1100 watts $210 shipped

1100 WATT DIGITAL POWER AMPLIFIER

Series II Class D Mono Advanced High Efficiency Digital Design

Cascade with an Additional DB-1100D for 2200 Watts RMS Power @ 2 Ohms.

1 x 330 WRMS @ 4 Ohm Mono .05% THD.

1 x 650 WRMS @ 2 Ohm Mono .1% THD.

1 x 1100 @ 1 Ohm Mono .5% THD.

High Thermal Efficiency Heat Sink Design

Distinctive Back Lit Logo Badge

Signal to Noise Ratio -90dB

Variable Input Sensitivity 250mV to 6V

Variable Low Pass Filter 15-50 Hz

Variable Sub-Sonic Filter 15-50 Hz

Variable Phase Control 0-180 Deg.

Remote Gain Control

Current and Thermal Protection

 
ill pass u live in ca i live in nc that equals a lot for shipping so i definitly wont sell for $200 shipped

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Subs play to the beat with gain low but if I turn it up my subs play loud unwanted never ending bass that is constant and wont stop until I turn...
0
10
Subs play to the beat with gain low but if I turn it up my subs play loud unwanted never ending bass that is constant and wont stop until I turn...
0
7
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
2
221
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
425

About this thread

weDoog

10+ year member
Senior VIP Member
Thread starter
weDoog
Joined
Location
NC
Start date
Participants
Who Replied
Replies
12
Views
964
Last reply date
Last reply from
nswartley
Screenshot_20240609-212906.png

Blackout67

    Jun 9, 2024
  • 0
  • 0
Screenshot_20240609-212805.png

Blackout67

    Jun 9, 2024
  • 0
  • 0

New threads

Top