FS is my Phoenix Gold/Xenon x600.1 monoblock amp that I've had for a total of 2 weeks. I ran this for 2 days on a DD1010 before I noticed the a slight tear in the cone of the sub. Until then, the amp sounded really nice and pounded. The amp has been disconnected since then, and like I said above, it was hooked up a total of 2 days. This is a refurb bought from Sonic Electronix and has a birth sheet of 826. It also comeswith the bass/gain control knob which I had to buy separate. I sure would like to keep it, but, now I have a new set of subs and need more power. $175 shipped
Heres the specs:
* Phoenix Gold's new optimized technology means full power output at any impedance (ohm) load
* 600 Watts RMS x 1 @ 4 ohms
* 600 Watts RMS x 1 @ 3 ohms
* 600 Watts RMS x 1 @ 2 ohms
* 600 Watts RMS x 1 @ 1 ohm
* variable thermal feedback controlled Cooling fans
* 24dB Linkwitz-Riley low pass and subsonic filter
* High efficiency (greater than 80%) Class D Operation
* Buffered RCA full range thru output
* Remote Monitoring Display (RMD) port
* Low Pass Level control ready (LPL-44)
* CEA-2006 approved
# Dimensions: 18.25L x 10.6W x 2.5H
Heres the specs:
* Phoenix Gold's new optimized technology means full power output at any impedance (ohm) load
* 600 Watts RMS x 1 @ 4 ohms
* 600 Watts RMS x 1 @ 3 ohms
* 600 Watts RMS x 1 @ 2 ohms
* 600 Watts RMS x 1 @ 1 ohm
* variable thermal feedback controlled Cooling fans
* 24dB Linkwitz-Riley low pass and subsonic filter
* High efficiency (greater than 80%) Class D Operation
* Buffered RCA full range thru output
* Remote Monitoring Display (RMD) port
* Low Pass Level control ready (LPL-44)
* CEA-2006 approved
# Dimensions: 18.25L x 10.6W x 2.5H
