Hello everyone. Up for sale is my Kicker 550.2. Birthsheet reads 655watts. Cosmetically it has normal wear and tear. My grandfather put duck tape on the amp while I was deployed over seas so I would know where to put the wires again, once I got back home. You will see what I mean in the pictures. Mechanically, this amp is flawless. It has never overheated. I am the only owner.. was ran semi daily on a Type R bridged. Here are the specs:
# 205 watts RMS x 2 at 4 ohms
# 275 watts RMS x 2 at 2 ohms
# 550 watts RMS x 1 in bridged mode
# remote level control included with with 20' cable (NOT INCLUDED)
# stereo or bridged mono output
# 4-ohm stable in bridged mode
# Tri-Way capable
# 3-way protection circuitry
# speaker- and preamp-level inputs
# bass boost (0-18 dB) centered at 40 Hz
# variable high-/low-pass crossover (50-200 Hz, 12 dB per octave)
# frequency response: 20Hz - 20kHz
# preamp outputs
# two 40-amp fuses
# requires 4-gauge power and ground leads and a 70-amp ANL fuse — wiring and hardware not included with amplifier
# Dimensions: 22-1/2"W (with endcaps) x 2-9/16"H x 9-15/16"D
This amp is somewhere around 3-4 years old.. Bought locally brand new at a dealership..
NOTE** This amplifier comes with END CAPS however, I cannot find the screws to them.
Also included in this is the Bass knob, without the wire, the original box and the original owners manual.
Price, Payment & Shipping:
I'm going to say $100.00 shipped. Paypal with verified addresses only! Shipping will be through Fedex ground. US ONLY.
References:
I have several references on here as a buyer and seller. I'm still awaiting some feedback on a pair of w6v2s,type R & memphis belle I just sold in the last week. I also have references on ClubRSX and my mothers EBAY account.
If you have any questions, please do not hesitate to ask.
Thanks for looking.
# 205 watts RMS x 2 at 4 ohms
# 275 watts RMS x 2 at 2 ohms
# 550 watts RMS x 1 in bridged mode
# remote level control included with with 20' cable (NOT INCLUDED)
# stereo or bridged mono output
# 4-ohm stable in bridged mode
# Tri-Way capable
# 3-way protection circuitry
# speaker- and preamp-level inputs
# bass boost (0-18 dB) centered at 40 Hz
# variable high-/low-pass crossover (50-200 Hz, 12 dB per octave)
# frequency response: 20Hz - 20kHz
# preamp outputs
# two 40-amp fuses
# requires 4-gauge power and ground leads and a 70-amp ANL fuse — wiring and hardware not included with amplifier
# Dimensions: 22-1/2"W (with endcaps) x 2-9/16"H x 9-15/16"D
This amp is somewhere around 3-4 years old.. Bought locally brand new at a dealership..
NOTE** This amplifier comes with END CAPS however, I cannot find the screws to them.
Also included in this is the Bass knob, without the wire, the original box and the original owners manual.
Price, Payment & Shipping:
I'm going to say $100.00 shipped. Paypal with verified addresses only! Shipping will be through Fedex ground. US ONLY.
References:
I have several references on here as a buyer and seller. I'm still awaiting some feedback on a pair of w6v2s,type R & memphis belle I just sold in the last week. I also have references on ClubRSX and my mothers EBAY account.
If you have any questions, please do not hesitate to ask.
Thanks for looking.
