fosgate p400x4 connection advice for re xxx6.5c

[bamby]

Hi i have a pair of re xxx 6.5c component speaker rated at 150Wrms each one. The p400x4 amplifier said 154wrms ch1 and ch2, 149wrms ch3 and ch4 on the dyno numbers that came in the box. I think the speakers need more power after testing today. they are connected in ch1 and ch2. ch3 and ch4 are used for the rear speaker. i have another amp stored that i can connect my rear speakers. Can i connect them bridged? i know that the amp says not stable at 1Ohm but dont know if by they being speaker and not playing low frequencys may not be to hard on the amp and can possibly get away with it they are crossed at 80hz. thanks

Click to read more...

 

[bamby]

The speaker are two way component running through their pasiive crosover giving a final inpedance off 2ohm per side. Didnt know if i was clear. Just asking if i could bridge ch1 and ch2 for un side and ch3 and ch4 for the other side.

Thanks

 

[Chavoya77]

The speaker are two way component running through their pasiive crosover giving a final inpedance off 2ohm per side. Didnt know if i was clear. Just asking if i could bridge ch1 and ch2 for un side and ch3 and ch4 for the other side.
Thanks[/quote

Did bridging the p400x4 work out for you?