Finally Killed my doors (deadened) no 56k

[Megalomaniac 5,000+ posts]

im going to require a new run of speaker wire...getting through door boots is easier then many think

i'll do it when i get some more time, man its going to be a bish to take that mid out to do so.

 

[Worlddre 5,000+ posts]

but you will have fun

 

[Megalomaniac 5,000+ posts]

guess what comes in monday //content.invisioncic.com/y282845/emoticons/naughty.gif.94359f346c0f1259df8038d60b41863e.gif

 

[Twistid 5,000+ posts]

men's glasses?

 

[Megalomaniac 5,000+ posts]

not exactly

 

[IamDeMan 5,000+ posts]

not exactly

fleshlight?

 

[Atimm693 10+ year member]

Moofers?

 

[Megalomaniac 5,000+ posts]

yea

 

[XanderMoser 10+ year member]

um hard to say. amp does 85x4 @ 4, and im running passive(using only 2 channels), so i have no clue what power it distributes to the mids. so i'll just say 65 watts to be safe.

Are you running each side off of one channel of that amp? Are your gains set correctly? Then you can say you're getting 85 watts per mid. When you use a passive crossover, it sends the signal to the proper driver, depending on the frequency. The drivers will share the signal around the crossover frequency, which probably has a slope of 12 db/oct. But once you get more than 2 or 3 octaves from the crossover freq, the tweeter or the mid is getting pretty much all of the power, depending on if the freq is higher or lower than the crossover freq.

Nice job deadening, I'll get around to doing my doors properly some day...

 

[nickk678 10+ year member]

so you use the mat on everything, then use the foam ontop of the mat on the inside of the door?

That's how it works. The mat is supposed to stop the vibrations/rattles, while the mat shields the soundwaves. Check out my sound deadener thread - I think i have some pictures of it in there.

http://www.caraudio.com/forum/showthread.php?t=205495

 

[bjayjr5679 10+ year member]

how much damplifier did you use?

 

[Megalomaniac 5,000+ posts]

20sq ft; i probally should have bought more so i could do several multiple layers

 

[quakerroatmeal 10+ year member]

Did the edead paste not work that you needed more dampening? Looks like you have a fairly thick layer of edead on there. Are you going to invert the sub like u had the MX?

 

[Megalomaniac 5,000+ posts]

the eDead was just a mass loader like damplifier. what i probally should have done, was use the damplifier first then go over it with the liquid deadener then the overkill.

yes

 

[NeverEnuffBass 10+ year member]

so whats up with the body filler?