X2 //content.invisioncic.com/y282845/emoticons/eek.gif.771b7a90cf45cabdc554ff1121c21c4a.gifLooks awesome //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif
PSP you need to do layers and make the top layer transparent to whatever percent you likedude, howd you do that pic in your sig? hella sick
I sealed my accords vent off with tape because that flap sound was soo annoying.
get under the rear of your vehicle and look behind the tire well thru the bumper. if you see a square/plastic rectangle thing there that may very well be the pressure release vent. when found go in your trunk and remove the side wall carpetting. you should then see the vent. you can either A, remove the flapper in there and leave the vent open, but itwill cause lots of road dust to enter the trunk. B, remove the flap and tape the area closed and sealed., this most likely cause a poping in your ears sometimes when you close your car door. it'll also be a little harder to close the door, not by much but requires a little more effort. and C. what i did with mine.. still got the pressure release and a filter to keep the dirt out the car.Holy ****, THAT's what that is? When I hit really low notes, I hear this "fap fap fap" noise that sounds like a midget is masturbating in my spare tire well. Where can I find this vent?
you'll need an alpine 9887 and the alpine KTX-100EQ. the EQ connects to the computer and car and configures the system with the program.Sweet. Thanks. Also, one more question though. What software did you use to flatten out the response in your car? Is that something that came with your headunit or something? I'm going to be installing some components and a 4ch. amp soon and that looks like a great way to dial in the settings.