fabricator needed $$$$

[dailyrider123]

who on here can fabricate some kickpanels? a friend of mines need some and hes paying so please if you do this type of work, please leave the best way to contact you so details can be discussed thanks guys.

Click to read more...

 

[C1500martin 10+ year member]

Looked into qlogic kick panels?

 

[Boomin_tahoe 5,000+ posts]

Might find some on ebay fairly enexpensive.

Unless you have the tools and car close by, I would go with q-logic.

 

[big scott]

like said, one would need the car in order to fab some up.

were are you??

 

[dailyrider123]

I'm in conyers Ga. But I can have him send you the panels to work on? I believe in his truck you can snap them out just like q logics but he wants 8" mids instead of 6.5s

 

[Boomin_tahoe 5,000+ posts]

Is there room for 8" mids? And why such big mids? Is he going to have a monster system or...?

 

[big scott]

I'm in conyers Ga. But I can have him send you the panels to work on? I believe in his truck you can snap them out just like q logics but he wants 8" mids instead of 6.5s

i can do them.

but i will not without the truck.

as i would need to fit it within the truck. to make sure it fits right.

he needs to see if he has room for 8" .

as 8" may be to big for the kick panel.

look around were you are for a shop that can do it.

 

[Boomin_tahoe 5,000+ posts]

man scott...you and I are on the same page //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[dailyrider123]

Thanks guys I was just trying to see if there was a better route for him to go, he got quoted like $600 bucks for some to be made by a shop close to him.

 

[disturbed471985 5,000+ posts]

Just keep this post up or make new one looking for someone near him. May have to travel a state over or so but will be worth it.. When its time for my doors and such to be done I will find someone on here prob deep south or e. texas and make the 4- 5 hour drive to them..