Enclosure design for 2 18" FI Q's.

  • 1
    Participant count
  • Participant list

bass-aholic
10+ year member

CarAudio.com Veteran
2,138
1
New York
Hello everyone. I have decided to go with 2 18" Q's for my new setup and I am in need of a enclosure design. If anyone has a design for a box that might work and would share it I would greatly appreciate it. If not I can paypal someone to design me a box, just send me a PM.

This is for a ford explorer XLT and I would like to have subs up and port back. My usable external dimensions are 44" left to right, 30" front to back, and 20" high. It should be about 15.2cu ft gross and after port area I am hoping for 6-7cu ft per sub. I would like tuning to be around 30-33hz and I want to do a rectangle port with not bends or angles. Thanks in advanced!

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Could not tell you, but you may want to start by going to crutchfield and get a consensus on the 7 or so replacements they recommend. That average...
1
799
You could try to make the port longer, but there might be other reasons with the box won't extend lower, or even the sub. You'd have to reverse...
3
796

About this thread

bass-aholic

10+ year member
CarAudio.com Veteran
Thread starter
bass-aholic
Joined
Location
New York
Start date
Participants
Who Replied
Replies
0
Views
517
Last reply date
Last reply from
bass-aholic
Buick Amp Connector.JPG

maylar

    Jun 2, 2024
  • 0
  • 0
1717274743729.png

Doxquzme

    Jun 1, 2024
  • 0
  • 0

New threads

Top