Enclosure bracing help needed

[S1R-BLUNTZWORTH 10+ year member]

Getting prepared to build the enclosure for my 2 hdc315's. Wondering if using 2x2's for bracing would work(see diagram)

Port will be in the middle, do I even need any bracing?

Any other input would also be greatly appreciated //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

Josh

planning on using rhino liner on the outside of this box, and a couple coats of spray-on rubber on the inside- might sound less hollow:laugh:

EDIT: how bout' this one??

Click to read more...

 

[misfit138 5,000+ posts]

those diagrams are wonderful

 

[zierbox 10+ year member]

Just use the same material as the box

¾ mdf works well, if needed double it

 

[S1R-BLUNTZWORTH 10+ year member]

looks very nice, but way too complicated man... this will be my first enclosure with volume measurements, calculations, tuning, etc..

I used to make boxes when I was a young boy, but they were pathetic. no science to em, they were just slop boxes

 

[ginxdor 10+ year member]

I'm trying at my first sub enclosure also and as far as I know you should brace as much as you can. I got some good bracing tips from the JL audio site.

http://mobile.jlaudio.com/support_pages.php?page_id=141

Hope this helps.