Distro Block

[DonH 5,000+ posts]

ok so i have seen some blocks that allow fuses and some that dont. I want to use a distributor block cuz im gona install two amps. Will be running 4 guage wire with 100a fuse to a 2 farad cap then from there into a distro block the two 8 guage runes to an old profile 4 ch. amp that has a 25 amp fuse on board then also a run of 8g to a fusion PP AM-20010. will this b ok? i know u guys hate caps but i like the fact that it filters the noise since w/out one its all noisy! will 4awg b ok? or should i go to 1/0g then to a distro block with 4 guage outs? the only prob with coing that would be my old profile does not accept 4g on 8g or less.

any input is awesome! thx guys!

oh and eventually will be adding a sepreate battery but for now this.

Click to read more...

 

[wu501 10+ year member]

wat

 

[dragnix 5,000+ posts]

better check your system again if it's making noise without a cap

 

[DonH 5,000+ posts]

better check your system again if it's making noise without a cap

as in engine noise its not the rca's either

 

[cf2004 10+ year member]

better check your system again if it's making noise without a cap

x2

what kind of power is that fusion putting out?

 

[GreenBook 10+ year member]

you could do what I did and instead of buying a distrobution block just have the wires fork off straight from the cap.

 

[DonH 5,000+ posts]

x2
what kind of power is that fusion putting out?

well they rate it at 1200rms at 1 ohm.