Did I wire my subs right?

If there Dual 4 then wire all the + to the + on the amp and like so with -.

if single 4 then you will get a final load of 2ohms.

 
For connecting two 4ohm subs at a 1 ohm load, the diagram shows both +'s of one sub being connected and I think both -'s of the other being connected. Do I just use a jumper to connect them?
For all of those asking if they're dvc there's your answer. //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Dammned that sounds good!! I usually dont eat out. But Hmm. Tempting
91
5K
Ya man. Thats No Good. As Stated. More than likely blew the power supply. I had an amplifier behind a rear truck seat and I forgot about the...
5
999
Yes, it was designed with the help of Steve at Amp Medics. They are great amps, I have many friends that run them.
5
2K
Send it means play it. I didn't say send it back. I'm sure it's fine.
43
5K
Thinking I will go 4th order. 3- 1 if i have the room for it. Motors to the front to help them cool faster.... and we are painting the baskets to...
12
1K

About this thread

thepope3290

10+ year member
Member
Thread starter
thepope3290
Joined
Location
Thomson, IL
Start date
Participants
Who Replied
Replies
12
Views
686
Last reply date
Last reply from
azbass
1715565471722.png

Doxquzme

    May 12, 2024
  • 0
  • 0
IMG_5880.jpeg

Brendon Jenness

    May 11, 2024
  • 0
  • 0

New threads

Top