d1 coil reading 1.8 -1.9???

  • 5
    Participant count
  • Participant list
its my apxx that I just checked in my room... I think that I will check the coils this weekend with my fluke though... but if they are .7 would it be bad to run my saz 3500 @ .35 daily?? granted there will be some rise, or should I just wire it to 1.4, will there be any audible difference between the two?? I guess 1.4 would be the better choice but those apxx's need lots o powa to get movin....

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

2x 4 ohm coils can be wired parallel to 2 ohms or series to 8 ohms. There's many amps with 2 ohm power you can use.
3
711
Not a term, a description. When it clips, it sends a distorted signal (current) through. A square wave contains more energy than a sine wave and...
27
3K
Okay i found one under b stock on alphards shop site but unable to actually place order grrr
1
3K

About this thread

RangerDangerV2

5,000+ posts
CarAudio.com Veteran
Thread starter
RangerDangerV2
Joined
Location
st cloud MN
Start date
Participants
Who Replied
Replies
6
Views
682
Last reply date
Last reply from
RangerDangerV2
Screenshot 2024-05-31 182935.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0
Screenshot 2024-05-31 182324.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0

New threads

Top