marvinwillis 10+ year member
Senior VIP Member
What should i use? Hole saw or Dremel? Trying to cut some holes for some speaker pods for my 6.5s
i found a 5.5 inch hole saw, is this good for a 6.5 speaker? i just need it to fit where it shows like thisif you can get a whole saw big enough that is the best way but if you dont care how it looks and have another tool that can do the job already then use it, it will be much cheaper. as long as you do an ok job the speaker will cover the hole up enough that it will not show.
its a pod you attach to the door i got the pod i just need to make a holeWhat's shown in the pic is probably fiberglass work and not just done by simply cutting a hole in the door panel. Yikes.
x2.OHHHHHHHHHHHHHHH in that case , screw a hole saw. Just use a jig saw or a dremel. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif