Custom 15" AQ HDC3 "big gap"

[disturbed471985 5,000+ posts]

Item(s) for Sale:

AQ HDC3 "big gap" motor. Lightning audio basket. Sundown zv3 cone and surround. Sundown zv4 coil. 3" 8layer coil using dual nomex 10" spiders. Built by splaudio. Dual 1ohm.

Item(s) Description/Condition:

10/10 mech with a slight rub on surround that's pure surface does not go deep an is less then half an inch long. Cosmetic 9.5/10. Has around 8-10 hours on it. Only selling cause I have my TC 5200 up and running and this just sits on table with no future in my setup. Priced to sell as the softs almost cost the asking price. Just want enough out of it to get a few mics things.. paid a lot more in April when I bought it...

Price:

$185

Shipping and Miscellaneous Item Information:

You pay.

Item Pictures:

(List pictures in this section, 1st picture should be your username/date if you have less than 10 positive feedbacks with the i-Trader system or less than 10 references that you have sold to in the past. (These must be listed in your signature, or a link provided to a feedback thread listing these references)).

View attachment 26554923View attachment 26554924View attachment 26554925View attachment 26554926

Click to read more...

 

[disturbed471985 5,000+ posts]

Hey buddy did you recone the 5200 or running it as is?
How much shipped to 91723?

Have recone sitting in room ready for drop in.. But right now still on stock taking my 2 fsd2600's daily... Want be long though. Thermo its doing ok can get a solid 30min full tilt on it before I have to shut it down due to heat. Mech is where its going to fail "spiders want hold much longer... Currently looking for another Tc 5200 motor as I want to run twins with a fsd at .33ohm on each..

 

---------- Post added at 01:20 AM ---------- Previous post was at 01:19 AM ----------

 

P.S this sub has been sold... AQ is GONE