curious about 2 MX's

[TruckAudioMan 10+ year member]

I have been debating on putting 2 15" MX's with about 2k watts each in the bed of my truck running through a cut through. Does anyone know about how loud this should get roughly??? Will 2 15" MX's cause some flex within my panels etc on my Silverado????

Click to read more...

 

[rtillaree 10+ year member]

my single 12 MX causes flex in my car, minor windshield and pretty noticeable rear glass flex as well as serious deck lid movement...

but it's all based on install, im sure with the small cab and the right size enclosure your truck should have some righteous movement...

 

[TruckAudioMan 10+ year member]

Sorry, little misunderstanding. It will not be in the cab of the truck, it is going to be in the bed of the truck and funneled into the cab of the truck. I had two previous cut throughs, both RF. Honestly, i love my P3's in my little Ranger with the cuthrough, but I think with this new truck I step it way up. If I didn't think a pacman box would take up the entire bed of the truck, I would put 4 15's in, but I think it would take up the entire bed.

 

[rtillaree 10+ year member]

right, go that...will you port it and if so will it not port into the cab? or is it going to be sealed up?

 

[TruckAudioMan 10+ year member]

My bad, I said funneled thinkin about puttin 4 15's in the pacman enclosure with ports. With two, it will port directly into the cab.

 

[audioholic 5,000+ posts]

Uhm, well it should get really loud. But Im sure you can imagine that as easily as we can. If you are asking anything more specific than that, you'll just be getting guesses. Might as well toss darts at a dartboard.