CSS SDX15: 4 cubes @ 25

[hempy 10+ year member]

More work today. I love the break. I hope to actually be done before classes begin on the 14th.

Everything mocked up to round the corners on the baffle and back panel:

Siliconed everything up (just to be sure):

I've been searching for a while for stuff to line the walls of enclosures. Batting is always too thin and expensive, foam sheets are expensive and small, but I found this stuff today at Wally World for 9 bucks. I also think I'll have enough extra to do my ht enclosure.

I picked up this to run the power wires through. I can't seem to find any smaller ones for the speaker/rca wires though.

I finally found a way to connect the aero port tubes to the 90* elbows that I got at Lowe's. I used some foam pipe insulation and hot glued it around the tube. It sits tight and won't move or shift.

 

[GSRswapandslow 10+ year member]

you do stained glass too?

 

[hempy 10+ year member]

you do stained glass too?

No, my gf's mom does. I just use their garage. 3-car ftw.

 

[GSRswapandslow 10+ year member]

nice

 

[hempy 10+ year member]

Lining all cut and glued up:

It's starting to look more like a comfy casket:

Ports:

A little messy on the joints with the elbows. I might use some electical tape to smooth it out:

 

[hempy 10+ year member]

Roughed up the inside a little so glue will stick better:

Almost there:

 

[z71tahoe 10+ year member]

Nice job....what effect does the foam padding have on the performance?

 

[Immacomputer 10+ year member]

Looks very sexy. I can't wait to hear how it performs. I love the way the foam looks!

 

[Skip01 5,000+ posts]

COMEONNNNN...hook it up....ill come take a vid ASAP

 

[hempy 10+ year member]

Haha. I don't even know when I'll be able to put it in the car. I hope to be done by the 14th.

I don't really know about the foam. I just follow the manufacturer's recommendations.

 

[BrianChia 10+ year member]

you should do a stained glass window on the side.

 

[hempy 10+ year member]

//content.invisioncic.com/y282845/emoticons/wow.gif.23d729408e9177caa2a0ed6a2ba6588e.gif

 

[twisztdauthorit 10+ year member]

for some unknown reason, that foam looks pretty tight, must be the swirls?

 

[MemphisLove. 10+ year member]

for some unknown reason, that foam looks pretty tight, must be the swirls?

haha agreed,

does it work kinda like polyfil?

 

[Blove1991 10+ year member]

You should do the bottom of the baffle too //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif