link doesnt show anything.. says no search items or somethinghttps://weldingsupply.securesites.com/cgi-bin/einstein.pl
Go down about mid way.. $9
fixed.ttt.. and btw you can move this i just realized i posted in wrong section.. my head is elsewhere today
mehttt.. and btw you can move this i just realized i posted in wrong thread.. my head is elsewhere today
ya but with how many wires im running and the routes im running them im just running some of them through the truck cutting them and crimping right there.. so need something hand heldI been using a large table vise at work. Works extremely well //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif
judging by your forum posts its good that you play the role of grammar police and not car audio guru.. thanks btwfixed.
i usually tap em witha hammer to get em to roll over then vise but like i said running all those wires alot of them i just run them off the spool and cut and splice in place.. tons easier and dont waste any wire at all.. plaus would be nice o have something around to no have to **** with the vice anymoreI use a vice to then use a hole punch to punch some teeth into them... but ya that would be tough with all your wire