Circular Saw>Fingers*nws*

Maybe this should be bumped to the enclosure and box design then..??//content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 
Not too bad. I work around someone that never uses a push stick and likes to turn the blade off before the cut is even done on bigger pieces. I told him that he better not screw up b/c I will be on the floor asleep when his fingers hit the ground. uuugh.

 
i did the same to my fingers like 4 months ago.me and a homie was workin on our rides.i also didn't have the gaurd on ,tryin to hurry and cut the wood.bammmm it happened.it didn't hurt at 1st just sting there after,i was really mad i done it because i had so much to do that day.now its well again:D

 
i did the same to my fingers like 4 months ago.me and a homie was workin on our rides.i also didn't have the gaurd on ,tryin to hurry and cut the wood.bammmm it happened.it didn't hurt at 1st just sting there after,i was really mad i done it because i had so much to do that day.now its well again:D
Did you get it put back on?

 
I've seen worse from a saw //content.invisioncic.com/y282845/emoticons/crap.gif.7f4dd41e3e9b23fbd170a1ee6f65cecc.gif
Same here unfortunately.

Watched my uncle slip on something while the saw was spinning (some1 else was cutting) his wrist landed on the say and it cut perfectly through the inside of his wrist and even jarred up the bone a bit.

Luckily enough no one went into panic, we tied it up about 2-3" above the wound, as well as the wound it self (just to keep pressure on it) while we had some1 else call for an ambulance.

It was like a garden hose of blood squirting with each beat of the heart, the garage looked like a murder scene.

 
Activity
No one is currently typing a reply...

Similar threads

About this thread

hzsogood

5,000+ posts
**The Clean South**
Thread starter
hzsogood
Joined
Location
TX/MN
Start date
Participants
Who Replied
Replies
19
Views
452
Last reply date
Last reply from
Captain_Ahab
IMG_20260506_140749.jpg

74eldiablo

    May 22, 2026
  • 0
  • 0
design.jpeg

WNCTracker

    May 22, 2026
  • 0
  • 0

New threads

Top