CDT NF-6902 package install help

[$H03gazer]

Hello,

I am new to audio and electrical tech.

I recently purchased the CDT https://cdtaudio.com/carspecific/nf6902.php package for my Nissan Frontier.

It lists a 4 ohm impedance for everything, but multimeter testing showed 2.1 ohms for the 6.5 rear fill, 2.2 ohms for the 6x9 components, and 4 ohms for the 2 inch tweeters.

Am I not understanding the specs or did they send me the wrong mids?

I would call them, but they are closed on weekends, and I would like to install them asap.

Thanks for any help.

Click to read more...

 

[mylows10 5,000+ posts]

Ken prolly sent the 2 ohm kids to pull more power from your amp to be louder the components will sound louder because they are closer to your ears But when you hook the components up to the crossovers. You should see a 4 ohm Lias

 

[wew lad 5,000+ posts]

Hello,
I am new to audio and electrical tech.

I recently purchased the CDT https://cdtaudio.com/carspecific/nf6902.php package for my Nissan Frontier.

It lists a 4 ohm impedance for everything, but multimeter testing showed 2.1 ohms for the 6.5 rear fill, 2.2 ohms for the 6x9 components, and 4 ohms for the 2 inch tweeters.

Am I not understanding the specs or did they send me the wrong mids?

I would call them, but they are closed on weekends, and I would like to install them asap.

Thanks for any help.

are you testing it with or without the crossover wired up

 

[$H03gazer]

thanks for the reply mylows10.

 

[$H03gazer]

I tested each speaker individually. Ill connect everything and post back. TY!

 

[$H03gazer]

I connected a tweeter and 6x9 to the crossover, then a wire to the amp input- which in turn connected to multimeter: 2.7 ohms.

~Thanks for anymore thoughts

 

[$H03gazer]

Ken prolly sent the 2 ohm kids to pull more power from your amp to be louder the components will sound louder because they are closer to your ears But when you hook the components up to the crossovers. You should see a 4 ohm Lias

Will the 6.5 rear fill be too loud though?

~thx

 

[mylows10 5,000+ posts]

Will the 6.5 rear fill be too loud though?~thx

Shouldn’t be. But you can adjust the amps gain down to your liking

 

[$H03gazer]

Shouldn’t be. But you can adjust the amps gain down to your liking

Thanks for your helpful responses. You were right; I spoke with the gentleman with CDT and he confirmed the kit was planned this way.

 

[wew lad 5,000+ posts]

I connected a tweeter and 6x9 to the crossover, then a wire to the amp input- which in turn connected to multimeter: 2.7 ohms.
~Thanks for anymore thoughts

that's the correct impedence