Carpeting Tutorial

[baseballer1100 5,000+ posts]

When you do the straight bit how far in does the straight bit cut go? if that makes sense?

 

[bjfish11 5,000+ posts]

Yea makes sense. You will have to play with it to get the depth you need. You just have to adjust it and test fit your rabbited edge piece in there until you have a 1/16" gap or so.

So what I would do, is setup your rabbet bit first, and make sure it fits snugly into the groove, then adjust your depth of your straight cut bit from there.

Did I explain this ok?

 

[baseballer1100 5,000+ posts]

Yes and no. Im talking about this..

 

[bjfish11 5,000+ posts]

Gotcha. That just depends on how far you want your sides inset. Mine Inset a 1/4" so that cut is made an inch from the edge. Its just personal preference.

 

[baseballer1100 5,000+ posts]

Sweet im trying this out today.

 

[bjfish11 5,000+ posts]

Good luck man. Hope it works out for you. Let me know if you cant figure anything else out.

 

[baseballer1100 5,000+ posts]

For sure. Im going to need the luck lol.

 

[bjfish11 5,000+ posts]

Na, you have the equipment. It wont be too bad. How many routers do you have?