Bridging 2-Channel Amps
- Thread starter chiaxi2002
- Start date
- Replies 0
- Views 415
-
1Participant count
-
Participant list
-
chiaxi2002
Activity
No one is currently typing a reply...
Similar threads
That amp does not have the RCA summing feature. You will have to use RCA splitters at the amp. If you already have that, then check the gains.
- Started by BryceCC
- General Car Audio
Bridging the amplifier Mono(LPF)on that sub will work just fine @4ohms
- Started by StuBob5
- Amplifiers
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
- Started by William Melcic
- General Car Audio
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
- Started by RyanJ0022
- General Car Audio
Pretty much. It's just a nice kit.
A solo rite Scarlett 2i2, XLR mic and a loop back cable are my next purchases so I can get accurate phase...
- Started by JoeMama541
- Amplifiers
About this thread
New threads
-
Another VS ThreadLooking to go for a cheap SQL build in the back of my Jeep...
- Started by Blackout67
- Replies: 5
-
Running two pairs of component speakers activeHello everyone. I need some advice. I am considering...- Started by 6r33n3y3z
- Replies: 10
-
Im trying to hook up a 4 channel ampI currently have a stock head unit with stock amp with jbl...
- Started by William Melcic
- Replies: 2
-
Chrysler 300 Dual Battery/350A ALT Connection Help Needed.Hello, New member here. Intermediate knowledge, four...- Started by Virtuous Warrior
- Replies: 3
-
21 Ram 1500Ill try to keep it short. “Base 6 speaker system”. I upgraded...- Started by Dylansnut
- Replies: 1