boston pro60 and gt amp setup question

[98k15004x4]

Hi, i am new at all this so im sorry if this question is stupid but i have a set of boston acoustic pro 60's and they are rated at 125 rms each side at 3 ohms, i have heard these things can handle 300rms on each side no problem, but i don't want to over power them that much, i am looking at getting 2 boston gt20 amplifiers to power these, i want to use one amp for each side, the amp is rated at

2x45W Multi-Ch. Power @ 4-ohm (12.6VDC)

2x80W Multi-Ch. Power @ 2-ohm (12.6VDC)

1x165W Dual-Mono Power @ 4-ohm(12.6VDC)

1x220W Dual-Mono Power @ 2-ohm (12.6vdc)

so my question is how would i wire this up for a 3 ohm load ? and how much would the final rms wattage be? i don't get how to get between the 2 ohm loads and the 4 ohm loads to get a 3 ohm, again sorry if this is a dumb question and thank you

Click to read more...

 

[lostdaytomorrow 10+ year member]

Those two amps will work just fine. Just bridge each of them or run the PRO's biamped if you want