Best way to open up a sub hole

  • 3
    Participant count
  • Participant list

CheЯRyMan

cherrymancustoms.com
Heres the fastest way to open up a sub hole cutout you will need a router and .25 endmill. Use your router in a COUNTERCLOCKWISE motion. This allows the bit to run along inside the hole taking off fine amounts in a controlled way without digging into the cutout profile. Video Link


 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Who had that Badazzed Astro Van?? I remember going to Austin seeing that ride. That thing made Earth pavement move about 50 ft before I got close...
12
290
The Polks, the Kappas are great speakers and the Memphis units you have are good too. In your situation, keeping with the same dome material is...
9
466
I hear ya. There are so many good deals on speakers too. My kid is 16, so loud is better than SQ. LOL... I really like the sound of the PPI...
15
788
Avoid jvc 480bhs hard to see the display in the daytime even with the brightness all the way up also not as easy getting to the audio menu like...
5
817

About this thread

CheЯRyMan

cherrymancustoms.com
Thread starter
CheЯRyMan
Joined
Location
Jackson TN.
Start date
Participants
Who Replied
Replies
2
Views
655
Last reply date
Last reply from
DonH
1000008028.jpg

Mr FaceCaser

    May 20, 2024
  • 0
  • 0
1000008027.jpg

Mr FaceCaser

    May 20, 2024
  • 0
  • 0

New threads

Top