Bazooka pro 20 p500d

  • 2
    Participant count
  • Participant list

c_nitty
10+ year member

Senior VIP Member
Item(s) for Sale:[sOLD] Bazooka pro 20 p500d

Item(s) Description/Condition:Used Bazooka pro 20 p500d Older (and better made) Bazooka pro 20 p500d in very good condition. Comes with remote and cord.Here are specs:

*350 watts RMS x 1 at 4 ohms

*700 watts x 1 at 2 ohms

*1100 watts x 1 at 1 ohm

*frequency response 10-500 Hz

*35-250 Hz low-pass crossover, 12 dB per octave

*bass optimization circuit (0-18 dB boost at 42 Hz)

*subsonic filter (variable 15-35 Hz, 12 dB/octave) eliminates extreme low bass for cleaner performance

*signal-to-noise ratio 90 dB

*preamp outputs

*preamp inputs

*speaker inputs

*power LED indicator

*diagnostic LED indicator

*optional CHIL pack pumps antifreeze through amp for maximum cooling

*dimensions: 14-7/8"W x 2-9/16"H x 10"D no mounting hardware a few small marks work great only selling because I got more watts

Price:$85 shipped lower 48

Shipping and Miscellaneous Item Information:

Item Pictures:
DSCF6654.jpg
DSCF6657.jpg
DSCF6658.jpg


(List pictures in this section, 1st picture should be your username/date if you have less than 10 positive feedbacks with the i-Trader system or less than 10 references that you have sold to in the past. (These must be listed in your signature, or a link provided to a feedback thread listing these references)).

 
Last edited by a moderator:
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

$2500usd for all three Shipping and PayPal fees extra I have a few BNIB pro series in stock I'm moving. These 3 listed is a full 3way system...
0
372
Nope, Either or. If you own both, then it's a loss on one or the other less what you sell it for, right? The PAC is an easier install and that...
7
1K
That is strange there. Thats what Ive encountered with low voltage before . That Kenwood needed a Firmware update and that fixed that one when it...
17
2K

About this thread

c_nitty

10+ year member
Senior VIP Member
Thread starter
c_nitty
Joined
Location
Houston,Tx 77044
Start date
Participants
Who Replied
Replies
4
Views
1,446
Last reply date
Last reply from
c_nitty
1000007975.jpg

Mr FaceCaser

    May 16, 2024
  • 0
  • 0
1000007974.jpg

Mr FaceCaser

    May 16, 2024
  • 0
  • 0

New threads

Top