k heres the deal I have 2 x 6.5"s and wanted to hook them up to my amp, because my amp has 2 extra channels so I could give them more power than my deck could. So I hooked them up to my amp, and go to set my gain levels for them and my amp jumps in to protect. For some reasone if I set my gain below half and turn my volume up, my amp goes into protect. So I tore my rug up and pulled out all the wires 3 times over to make sure everythings wired right and had someone else to check and it is. I don't know whats going on if I run the gain below half on the 2 channels my 6.5's are hooked up to and put my volume over half my amp kicks into protect....any one know why? (sorry if this is so long)
